Manufacturing Solutions Inc.

back to Pinnacle safety products

MicroGuard® Safety Light Curtain

Brochure

User friendly

Continual system status checks

Easily viewed message display

Fits tight spaces

Highly reliable solid state performance

Meets OSHA, UL, ANSI, CSA, RIA, and CE standards

DeviceNetT capable

Designed to meet international standards

DIN-rail and Metal Box Controllers available

MicroGuard® Model SS Safety Light Curtain

Brochure / More...

The Model SS is an infrared safety light curtain that is designed to the IEC 61496 standard. When properly installed, it protects the machine operator by passing an invisible infrared light beam across an area to be guarded and examining whether or not the light beam(s) are blocked. If the light beam(s) are blocked, monitored solid state outputs will open, issuing a “STOP” command to the machines normally closed (N.C.) “STOP” circuit.

The System is composed of a transmitting unit (EMITTER), and a receiving unit (RECEIVER). The entire system is control reliable Category 4 (per IEC 61496). A single fault anywhere within the Model SS will not prevent at least one of the solid state outputs from opening up, (allowing a “STOP” command) when either a beam is broken or an internal fault occurs.

PPG Perimeter Guards

Brochure

Perimeter Guards utilize wider beam spacing than safety light curtains protecting personnel from "pinch point" or "point of operation" hazard zones. Perimeter Guards are designed to detect when an operator or passerby penetrates the perimeter of a hazardous zone.

The Perimeter Guard safety light curtain will then initiate a stop signal to the machine control. Perimeter Guards also incorporate latching safety relays.

This requires a manual reset after each penetration into the guarded zone.

This is an additional safety feature to protect the intruder from an inadvertent machine actuation while the intruder is within the work area.

Warning: Machine safety products sold by Manufacturing Solutions are Safety components only.

The purchaser/installer is solely responsible for the application of these components and ensuring all necessary steps have been taken to assure each application and use meets all performance and applicable safety requirements and/or local, national and/or international safety codes as required by the application. Manufacturing Solutions cannot certify that our products used solely or in conjunction with other Manufacturing Solutions or other vendors products will assure safety for any application.

Any person using or applying any products sold by Manufacturing Solutions is responsible for learning the safety requirements for their individual application and applying them, and therefore assumes all risks, and accepts full and complete responsibility for the selection and suitability of the product for their respective application.

Manufacturing Solutions does not provide design or consulting services, and cannot advise whether any specific application or use of our products would ensure compliance with the safety requirements for any application.